3.2.7. Digitizing Cables

3.2.7.1. General

TDH includes the SIA-405 extension in order to allow cables and cable_points to be digitized.

3.2.7.2. Digitizing

• Make sure that the automatic snapping tool is activated for all layers.

• Select the sia4005cc_cable layer in that layer panel and then select the edit mode.

• In digitizing mode the cursor will automatically snap to the nearest map objects. When left clicking a line starts to draw.

• With further left clicks anywhere you can define intermediary points of the cable progression. You can also directly select another soa405cc_cable_point to draw a straight line.

• You finish digitizing the line by right clicking. This will make the sia4005cc_cable feature attributes window appear and you can start adding data:

Select the function of the sia4005cc_cable you want (preselected is “control_cable”):

• control_cable

• others

• power_cable

• signal_cable

• unkown

Note

Keep in mind that the finishing point of the line is the last point where you left clicked. Thus, for digitizing a simple line with 2 points you need two left clicks to digitize the line and one right click to finish the line digitizing.

Note

If you do not enter an name_number identifier on this form, TDH will enter the obj_id also as identifier (you can change later).

• When finished, then click the OK button.

• Save the information of this layer by selecting the Floppy icon in the menu bar.

You can re-edit your polygon object selecting the edit mode and then click with the info cursor on the object you want to edit. If you do not select the edit mode, you can just look at the existing data.

For detailed information about editing see the Editing of existing data chapter.